Quantum DLT 8000 Manual descarregar pdf (Página 93)

Configuring, Installing, and Operating the Tape Drive

Quantum DLT 8000 Tape System 2-39

Table 2–12 Possible Tape System States Following Initialization (continued)

State Indicator Display and Activity

A tape cartridge is present, but

the handle is up (not

recommended)

The yellow Tape In Use indicator extinguishes. The green

Operate Handle indicator flashes. When the Insert/Release

Handle is lowered, the cartridge loads. If handle will not lower,

ensure the tape cartridge is pushed all the way into the tape

system.

The tape system detects an error

condition

Right- or left-hand indicators blink repeatedly. Try to unload the

tape and reinitialize the tape system by pressing the Unload

button, or turn system power off then back on. The indicators

stop blinking and the system attempts to reinitialize. Note that

after pressing the Unload button you may have to wait five

minutes before the Operate Handle indicator illuminates due to

the retry being attempted first. The indicators illuminate steadily,

then extinguish if the test succeeds.

The system is powered on with

the handle in open position

Operate Handle indicator is blinking. Close the Insert/Release

Handle and wait for indicator to illuminate steadily.

POST completes in about 15 seconds and the tape system should respond normally to all

commands (POST is complete after Stage 2 in Table 2-11). However, it might take

longer for the media to become ready.

After a bus reset, the tape system responds within a bus selection time-out period (per

the ANSI SCSI specification). A reset may have the Tape In Use indicator blinking

because a reset forces the tape to be rewound to BOT.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 407 408

Sem comentários

Quantum DLT 8000 Manual Página 93