Quantum DLT 8000 Manual descarregar pdf (Página 100)

100

101

Configuring, Installing, and Operating the Tape System

2-46 Quantum DLT 8000 Tape System

Table 2–15 Troubleshooting Chart (continued)

If… Then… You Should…

System does not recognize the

tape system (continued)

1. SCSI bus may be too long.

2. Too many devices on the

bus.

1. Limit bus length to ANSI

SCSI standard for the SCSI

interface being used.

2. Limit the number of

devices on the bus

(including the SCSI

adapter) to match the

limits of the interface

being used.

The tape system does not

power up

No power is reaching the tape

system

Check the tape system’s power

cable connection at the rear of

the system.

All right-hand or left-hand

indicators on the tape system

front panel are blinking

A system fault has occurred Try to unload the tape and

reinitialize the system by

pressing the Unload button, or

by turning power to the system

off then back on. The

indicators stop blinking as the

system attempts to reinitialize.

The indicators illuminate

steadily again, then extinguish

if the test succeeds.

CAUTION

If this happens multiple times, contact your service

representative.

Nonfatal or fatal errors occur

for which the cause cannot be

determined

SCSI bus termination or the

SCSI bus cable connections

may be incorrect

The ac power source

grounding may be incorrect

(tabletop version).

Ensure the SCSI bus is

terminated and that all

connections are secure.

Use an ac outlet for the

tabletop tape unit on the same

ac line used by the host

system.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 407 408

Comentários a estes Manuais

Sem comentários

Quantum DLT 8000 Manual Página 100

Comentários a estes Manuais

Manuais e produtos relacionados com Unidades de fita magnética Quantum DLT 8000