Quantum DLT 8000 Manual descarregar pdf (Página 393)

100

101

Appendix E: Visual Inspection Procedure for DLTtape Cartridges

Quantum DLT 8000 Tape System E-5

6. Ensure that the tape leader within the tape cartridge is in

the correct position. To do this, you must open the tape

cartridge door. Refer to Figure E-3.

Figure E-3 Opening the Door on a DLTtape Cartridge Showing Tape Leader Loop in its

Correct Position

Open the door by holding the DLTtape cartridge as shown

in Figure E-3.

On the right side corner of the tape cartridge there is a

small tab in a cut-out portion of the cartridge. Using your

thumb, gently lift up on the tab and swing the door open

(Figure E-3).

Inside the door, you will see the tape and cartridge leader

loop. The loop should stick up about an eighth of an inch

when viewed from the edge; the loop must be a closed loop.

If the loop is torn, bent, pulled in, or not sticking up about

an eighth of an inch, do not use the tape cartridge.

Leader Loop

1 2 ... 388 389 390 391 392 393 394 395 396 397 398 ... 407 408

Comentários a estes Manuais

Sem comentários

Quantum DLT 8000 Manual Página 393

Comentários a estes Manuais

Manuais e produtos relacionados com Unidades de fita magnética Quantum DLT 8000