Quantum DLT 8000 Manual descarregar pdf (Página 56)

Configuring, Installing, and Operating the Tape System

2-2 Quantum DLT 8000 Tape System

• Always handle the system carefully and gently. A drop of 1/4 inch onto a bench or

desktop may damage a system.

• Do not bump, jar, or drop the system. Use care when transporting the system.

• Never place the tape system so that it rests on its front bezel. Always gently place

the system flat, PCB side down, on an appropriate ESD-protected work surface to

avoid the system being accidentally knocked over.

• Do not pack other materials with the system in its shielded bag.

• Place the system in the anti-static bag before placing in shipping container.

• Do not stack objects on the system.

• Do not expose the system to moisture.

• Do not place hands or foreign objects inside the tape system’s door/receiver area.

• Do not touch the tape leader, cartridge leader, or tape media. Body oils will damage

the media and recording heads.

2.1.3 Electrostatic Discharge (ESD) Protection

Various electrical components on/within the tape system is sensitive to static electricity

and Electrostatic Discharge (ESD). Even a static buildup or discharge that is too slight

to feel can be sufficient to destroy or degrade a component's operation.

To minimize the possibility of ESD-related damage to the system, we strongly

recommend using both a properly installed workstation anti-static mat and a properly

installed ESD wrist strap. When correctly installed, these devices reduce the buildup of

static electricity, which might harm the system.

Observe the following precautions to avoid ESD-related problems:

• Use a properly installed anti-static pad on your work surface.

• Always use a properly fitted and grounded wrist strap or other suitable ESD

protection when handling the system and observe proper ESD grounding techniques.

• Hold the system only by its sides. Do not touch any components on the PCBA.

• Leave the system in its anti-static bag until you are ready to install it in the system.

• Place the system on a properly grounded anti-static work surface pad when it is out

of its protective anti-static bag.

• Do not use the bag as a substitute for the work surface anti-static pad. The outside

of the bag may not have the same anti-static properties as the inside. It could

actually increase the possibility of ESD problems.

• Do not use any test equipment to check components on the PCBA. There are no

user-serviceable components on the system.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 407 408

Sem comentários

Quantum DLT 8000 Manual Página 56