Quantum DLT 8000 Manual Página 234

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 233
SCSI Commands
5-90 Quantum DLT 8000 Tape System
MODE SELECT Command (6) / (10) (15h) / (55h) (continued)
Table 5–44 Device Configuration Page — Field Descriptions (continued)
Field Name Description
AVC Automatic Velocity Control. Not supported; must be 0.
SOCF Stop on Consecutive Filemarks. Not supported; must be 0.
RBO Recover Buffer Order. Not supported; must be 0.
REW Report Early Warning. Not supported; must be 0 (do not report Early
Warning EOM on READ).
Gap Size Not used; must be 0.
EOD Defined End-of-Data Defined. This field must be set to 00h.
EEG Enable End-of-Data Generation. Set to 1. This field indicates that the
drive will generate an EOD. The drive generates an EOD mark before any
change of direction following a WRITE-type operation. This bit is ignored,
however, on MODE SELECT.
SEW Synchronize at Early Warning. Must be set to 1.
Buffer Size at Early Warning Not supported; must be 0.
Select Data Compression
Algorithm
When set to 1, enables data compression.
When 0, disables data compression.
The setting on the front panel of the tape drive overrides any setting of
MODE SELECT, but no error will result. If the setting is returned to the
automatic mode on the front panel of the tape drive, the value from the
last MODE SELECT command determines whether compression is
enabled or disabled.
Vista de página 233
1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 407 408

Comentários a estes Manuais

Sem comentários