Quantum DLT 7 Manual descarregar pdf (Página 97)

Chapter 9 Installing an Internal SCSI Tape Drive

Using the Loader/Library Interface Connector

DLT-S4 Product Manual 79

Connect all additional tape drives and peripheral devices to the host

computer’s SCSI cable.

5 Ensure that a terminator is installed on the very last SCSI connector

on the SCSI cable.

6 Check all the cable and termination connections to ensure that they

are attached correctly and seated firmly.

7 Turn on power to the system and all attached devices.

8 Confirm the installation (see Confirming the Installation on page 78).

Using the Loader/Library Interface Connector 9

This connector is only used for tape drives installed in loaders/libraries.

If your system requires it to be used, it should have been pre-assembled

at the factory. For more information about the loader/library connector,

see Loader/Library Interface Connector

on page 46.

Note: Regardless of which device terminates the SCSI bus, that

device must have power applied and be powered on for

proper termination to occur.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 97