Quantum DLT 7 Manual descarregar pdf (Página 106)

Chapter 10 Installing an Internal Fibre Channel Tape Drive

Adding Additional Devices

DLT-S4 Product Manual 88

Adding Additional Devices 10

Once you have successfully confirmed the installation of your tape drive,

you may add additional devices.

For each additional device:

1 Ensure that both the tape drive and computer are turned off.

2 Insert the fiber optic cable into the Fibre Channel port on the device

(for tape drives see figure 33

The connector is fully seated when it snaps into the port.

3 Insert the other end of the fiber optic cable into the Fibre Channel

port on the host computer.

4 Check all cable connections and ensure that they are attached

correctly and seated firmly before turning the system on.

5 Confirm the installation (see Confirming the Installation on page 87).

Using the Loader/Library Interface Connector 10

This connector is only used for tape drives installed in loaders/libraries.

If your system requires it to be used, it should have been pre-assembled

at the factory. For more information about the loader/library connector,

see Loader/Library Interface Connector

on page 46.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 106