Quantum DLT 7 Manual descarregar pdf (Página 94)

Chapter 9 Installing an Internal SCSI Tape Drive

Connecting the Cables and Terminating the SCSI Bus

DLT-S4 Product Manual 76

Connect one of the SCSI connectors on the SCSI cable to the SCSI

connector on the rear panel of the tape drive (see figure 28

). The SCSI

connectors are keyed, preventing improper connection.

6 If not already connected, connect the other end of the SCSI cable to

the connector in the SCSI host adapter, aligning the colored stripe on

the cable with pin 1 on the SCSI host adapter’s connector.

7 Locate an available DC power cable in the host computer and attach

it to the power connector on the rear panel of the tape drive (see

figure 28

). The connector is keyed, preventing improper connection.

(See Power Connector Pin Assignments

on page 46 for power pin

number assignments and signal names.)

8 Check all the cable and termination connections to ensure that they

are attached correctly, seated firmly, and secured.

Figure 28 SCSI and Power

Cable Locations

SCSI cable (shown with

terminator installed)

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 94