Quantum DLT 7 Manual descarregar pdf (Página 134)

Chapter 13 Using the Tape Drive

Firmware Update via the Host Interface

DLT-S4 Product Manual 116

Firmware Update via the Host Interface 13

When you need to update the firmware in the tape drive, you can do it

either of two ways:

• Updating Firmware Using the Host Interface

• Creating a CUP/FUP Cartridge From Which to Update Firmware

(used in either a manual firmware update or in a library setting)

The xTalk Management Console tool allows you to update the tape

drive’s firmware using the host interface, or to create a CUP/FUP

cartridge for an DLT-S4 tape drive. See xTalk Management Console

page 135 for information on downloading and using xTalk Management

Console.

The following subsections briefly describe both methods of updating the

tape drive firmware.

Updating Firmware Using

the Host Interface

Use xTalk Management Console to update the firmware:

1 Follow the instructions for downloading xTalk Management Console

in xTalk Management Console

on page 135.

2 Follow the instructions in the xTalk Management Console User’s Guide

to download the firmware.

Creating a CUP/FUP

Cartridge From Which to

Update Firmware

Use xTalk Management Console to create a CUP/FUP cartridge:

1 Follow the instructions for downloading xTalk Management Console

in xTalk Management Console

on page 135.

2 Follow the instructions in the xTalk Management Console User’s Guide

to create a CUP/FUP cartridge.

Follow these steps to use a CUP/FUP cartridge:

1 Verify that the tape drive is turned on (power is applied), and the

middle LED on the front panel of the tape drive is on, but not

flashing.

2 Verify that the tape drive’s cartridge opening is empty. If a cartridge

is in the tape drive, unload and eject it before proceeding.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 134