Quantum DLT 7 Manual descarregar pdf (Página 122)

Chapter 12 Installing the Tabletop Tape Drive

Connecting the Tape Drive to the Host Computer and Terminating the SCSI Bus

DLT-S4 Product Manual 104

Follow these steps to connect the tape drive to the host computer (see

SCSI Connectors and Pin Assignments

on page 51 for more information):

1 Ensure that the tape drive, host computer, and all peripheral devices

(such as printers) are turned off.

2 Make sure that the SCSI cables and terminators are Ultra320 and

SPI-4 (or SPI-5) compatible.

3 Terminate the SCSI bus by attaching a SCSI terminator to either of the

connectors on the rear of the tape drive (see figure 40

4 Carefully connect one end of the SCSI cable into the open SCSI

connector on the rear of the tape drive (see figure 40

5 Carefully connect the other end of the SCSI cable to the SCSI

connector on the host computer (see figure 40

6 Check all the cable and termination connections to ensure that they

are attached correctly, seated firmly, and secure.

Note: Use care when connecting the cables to avoid bending or

damaging the connector pins.

Caution: Never connect the tape drive while the tape drive,

host system, or peripheral devices are turned on.

Doing so could result in damage to the tape drive or

other peripheral devices.

Note: SPI refers to SCSI Parallel Interface; you can learn more

from this standard at the Web site

www.t10.org.

Note: Regardless of which device terminates the SCSI bus, that

device must have power applied and be powered on for

proper termination to occur.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 122