Quantum DLT 7 Manual descarregar pdf (Página 113)

Chapter 11 Installing an Internal SAS Tape Drive

Connecting the Cables

DLT-S4 Product Manual 95

Connecting the Cables 11

Connect the SAS and power cables as follows:

1 Ensure that both the tape drive and computer are turned off.

2 Insert the SAS cable into the SAS port on the rear of the tape drive

(see figure 34

3 Insert the other end of the SAS cable into the SAS port on the host

computer.

4 Locate an available DC power cable in the host computer and attach

it to the power connector on the rear panel of the tape drive (see

figure 37

). The connector is keyed, preventing improper connection.

(See Power Connector Pin Assignments

on page 46 for power pin

number assignments and signal names.)

5 Check all the cable and termination connections to ensure that they

are attached correctly, seated firmly, and secured.

Note: If you are connecting several devices to the system,

connect only the tape drive to the host computer at this

time. Finish the installation procedure and confirm that

the host computer and tape drive are communicating

correctly before adding additional devices (see

Confirming the Installation

on page 96).

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 113