Quantum DLT 7 Manual Página 68
- Página / 177
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Chapter 6 Parallel SCSI Interface
SCSI Tape Drive Features
DLT-S4 Product Manual 50
Figure 16 SCSI Connectors
SCSI Tape Drive Features 6
The DLT-S4 tape drive conforms to the Ultra320 SCSI standard and
allows for a maximum burst rate of 320 MB per second.
Quantum recommends one DLT-S4 tape drive per bus, with a maximum
of two DLT-S4 tape drives per bus.
SCSI Stub and Cable Lengths 6
The longest stub length on the DLT-S4 PCBA is 1.64 inches, and the
maximum cable length for one DLT-S4 tape drive is 20 meters. The
maximum SCSI cable interconnect length is 10 meters total with a
maximum of two DLT-S4 tape drives on the bus.
To operate properly in Ultra320 mode, ensure that all SCSI cables and
terminators are Ultra320 (SPI-4) compatible.
For more information on the SCSI interface, see the DLT-S4 Interface
Reference Guide (81-81281-xx).
For information on transfer rates and protocol options, see table 4
on
page 11.
High-density 68-pin Micro DB68 or
Mini DB68
SCA 80-pin Hot Swap Connector
Very High-density Interconnect
Connector
- '/76 1
- Contents 3
- Chapter 3 Cartridges 19 4
- Chapter 4 Specifications 37 4
- DLT-S4 Product Manual v 5
- DLT-S4 Product Manual vi 6
- DLT-S4 Product Manual vii 7
- Glossary 144 8
- Index 153 8
- DLT-S4 Product Manual ix 9
- DLT-S4 Product Manual x 10
- DLT-S4 Product Manual xi 11
- DLT-S4 Product Manual xii 12
- DLT-S4 Product Manual xiii 13
- DLT-S4 Product Manual xiv 14
- DLT-S4 Product Manual xv 15
- Product Overview 19
- Tape Drive Models 1 20
- Chapter 1 Product Overview 21
- Tape Drive Models 21
- DLT-S4 Product Manual 3 21
- Figure 2 Tabletop Tape Drive 21
- Tape Drive Features 1 22
- Maximum Data Transfer Rate 1 23
- Functional Specifications 1 24
- Tape Drive Technology 1 25
- Tape Drive Components 1 26
- Tape Drive Components 27
- DLT-S4 Product Manual 9 27
- Integrated 28
- Interface Types 1 29
- Interface Types 30
- DLT-S4 Product Manual 12 30
- Physical Characteristics 30
- Before You Begin 31
- Warranty Note 2 32
- Safety Precautions 2 32
- Chapter 2 Before You Begin 33
- DLT-S4 Product Manual 15 33
- DLT-S4 Product Manual 16 34
- Figure 4 Receiver Area 34
- Pre-Installation Guidelines 2 35
- Cartridges 37
- Chapter 3 Cartridges 38
- DLT-S4 Product Manual 20 38
- Figure 5 Compatible Tape 38
- ≥ 18.0 MB/sec 40
- ≥ 8.0 MB/sec 40
- DLT-S4 Product Manual 23 41
- DLT-S4 Product Manual 24 42
- Inspecting a Cartridge 3 43
- Spring-loaded hub 44
- Reel lock 44
- Write-protecting a Cartridge 49
- DLT-S4 Product Manual 31 49
- Table 22 Write-protect Tab 49
- Positions 49
- Loading a Cartridge 3 50
- Unloading a Cartridge 3 51
- DLTSage WORM 3 52
- Specifications 55
- Physical Specifications 4 56
- Dimensions and Weights 4 57
- Acoustic Noise Emissions 4 60
- Common Interface 61
- Information 61
- SCSI Command Timeout 5 62
- Rear Panel Connectors 5 64
- Rear Panel Connectors 65
- DLT-S4 Product Manual 47 65
- Figure 14 ADI/Loader Port 65
- Interface Schematic 65
- Parallel SCSI Interface 66
- Rear Panel Connectors 6 67
- SCSI Cable Connectors 6 67
- SCSI Tape Drive Features 6 68
- SCSI Stub and Cable Lengths 6 68
- DLT-S4 Product Manual 52 70
- DLT-S4 Product Manual 54 72
- Fibre Channel Interface 73
- Rear Panel Connectors 7 74
- DLT-S4 Product Manual 57 75
- Connector 75
- Practical Considerations 7 76
- World-wide Names 7 79
- Serial Attached SCSI (SAS) 80
- Interface 80
- Rear Panel Connectors 8 81
- SAS Cable Connector 8 82
- SAS Tape Drive Features 8 82
- Practical Considerations 8 82
- SAS Tape Drive Speed 8 83
- World-wide Names 8 83
- Installing an Internal 84
- SCSI Tape Drive 84
- Equipment Required 9 85
- Installation Steps 9 85
- Rear Panel Connectors 9 86
- Unpacking the Tape Drive 9 87
- Setting the SCSI ID 9 87
- DLT-S4 Product Manual 73 91
- Built-in 93
- Terminator 93
- SCSI cable (shown with 94
- Setting TERMPWR 9 95
- Adding an Additional Device 9 96
- Installing an Internal Fibre 98
- Channel Tape Drive 98
- Equipment Required 10 99
- Installation Steps 10 99
- Rear Panel Connectors 10 100
- Unpacking the Tape Drive 10 101
- Mounting holes 102
- DLT-S4 Product Manual 85 103
- Holes — Bottom View 103
- Connecting the Cables 10 104
- DLT-S4 Product Manual 87 105
- Channel and Power Cables 105
- Confirming the Installation 105
- Adding Additional Devices 10 106
- Installing an Internal SAS 107
- Tape Drive 107
- Equipment Required 11 108
- Installation Steps 11 108
- Rear Panel Connectors 11 109
- Unpacking the Tape Drive 11 110
- DLT-S4 Product Manual 94 112
- Connecting the Cables 11 113
- DLT-S4 Product Manual 96 114
- Adding Additional Devices 11 115
- Installing the Tabletop 116
- Equipment Required 12 117
- Installation Steps 12 117
- Rear Panel Connectors 12 118
- DLT-S4 Product Manual 101 119
- Setting the SCSI ID 12 120
- Terminating the SCSI Bus 121
- SCSI cable 123
- 220V / 240V 124
- Configuring the Tape Drive 12 127
- Using TERMPWR 12 127
- Using the Tape Drive 128
- Eject button 129
- Left LED 129
- Middle LED 129
- Right LED 129
- Power-On Self-Test 13 131
- Performing a Trial Backup 13 133
- Cleaning the Tape Drive 13 137
- DLT-S4 Product Manual 121 139
- DLT-S4 Product Manual 122 140
- Troubleshooting 141
- Chapter 14 Troubleshooting 143
- POST and SCSI Troubleshooting 143
- DLT-S4 Product Manual 125 143
- Table 37 POST and SCSI 143
- Troubleshooting Guidelines 143
- DLT-S4 Product Manual 126 144
- DLT-S4 Product Manual 127 145
- Over Temperature Condition 14 146
- Preparing the Tape 147
- Drive for Shipping 147
- Power off the tape drive 148
- Diagnostic Tools 149
- Accessing the Tools 1 150
- Device Drivers 1 150
- TapeAlert 1 151
- Medium Auxiliary Memory 1 151
- DLTSage 1 152
- Appendix A Diagnostic Tools 153
- DLT-S4 Product Manual 135 153
- Environmental Compliance 155
- DLT-S4 Product Manual 138 156
- Regulatory Statements 157
- Taiwan Statement 3 158
- DLT-S4 Product Manual 141 159
- Laser Statement 3 160
- Power Cord Statement 3 161
- Glossary 162
- Numerics 171
Manuais e produtos relacionados com Unidades de fita magnética Quantum DLT 7
Unidades de fita magnética Quantum DLT 8000 Manual
(408 páginas)
(408 páginas)
Unidades de fita magnética Quantum DLT 7000 Manual
(312 páginas)
(312 páginas)
Unidades de fita magnética Quantum DLT 2500 Manual
(12 páginas)
(12 páginas)
Unidades de fita magnética Quantum Internal Storage System Travan 40 GB Manual do Utilizador
(26 páginas)
(26 páginas)
Unidades de fita magnética Quantum DLT 4000 Manual
(300 páginas)
(300 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais