Quantum DLT 7 Manual descarregar pdf (Página 135)

Chapter 13 Using the Tape Drive

Firmware Update via the Host Interface

DLT-S4 Product Manual 117

Press and hold the Eject button for six seconds; after six seconds, the

left LED begins to flash.

4 Release the Eject button, then quickly press and release the Eject

button again.

At this point, the left and middle LEDs start flashing synchronously

in a regular, rhythmic pattern. The tape drive is now in Firmware

Upgrade mode.

You now have a “window” of 3 minutes to insert the CUP/FUP

cartridge. If you do not insert a CUP/FUP cartridge and the 3-minute

window expires:

• Both LEDs stop flashing, although the middle LED remains on

(steadily illuminated)

• The tape drive is now out of Firmware Update mode and can be

used in a normal manner (once you insert a cartridge)

To put the tape drive back in Firmware Update mode, repeat steps 2

, and 4.

5 Insert the CUP/FUP cartridge.

After you insert the CUP/FUP cartridge, the left and middle LEDs

change their pattern and start flashing in an alternating pattern. The

tape drive is now performing the firmware update.

6 Wait several minutes for the update process to complete.

The left and middle LEDs flash the entire time that firmware is being

updated.

When the update is complete, the tape drive resets itself and goes

through POST. The tape drive rewinds the CUP/FUP cartridge, then

Note: The firmware update fails the update process if the

firmware personalities do not match. The history log

(accessible via the

LOG SENSE Page 07h) records this

information, as well as the reason for the failure.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 135