Quantum DLT 7 Manual descarregar pdf (Página 77)

Chapter 7 Fibre Channel Interface

Fibre Channel Speed and Topology

DLT-S4 Product Manual 59

Fibre Channel Speed and Topology 7

Although Fibre Channel DLT-S4 tape drives will auto-negotiate the speed

and topology, you may override the automatic selections by placing

jumpers on the Fibre Channel jumper block at the rear of the tape drive.

If you decide it is necessary to change the tape drive’s speed or topology,

use your fingers to move the jumpers to the pattern corresponding to the

speed or topology you want. Using this jumper block is optional.

See:

• Figure 17

for the Fibre Channel jumper block location

• Figure 19

for the empty jumper block that you use to set the speed

and topology

• Table 32

and table 33 for the various jumper setting combinations

Figure 19 Fibre Channel

Speed and Topology Jumper

Block

Note:

The tape drive only checks the jumpers at a power cycle. To

change the speed or topology configurations after installation,

turn off the tape drive, move the jumpers as needed, and then

turn on the tape drive.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 176 177

Sem comentários

Quantum DLT 7 Manual Página 77