
DLT-S4 Product Manual 66
Chapter 9
9Installing an Internal
SCSI Tape Drive
This chapter describes how to configure and install the DLT-S4 internal
SCSI tape drive.
This chapter includes the following information:
• Equipment Required
• Installation Steps
• Rear Panel Connectors
• Unpacking the Tape Drive
• Setting the SCSI ID
• Securing the Tape Drive in the System
• Connecting the Cables and Terminating the SCSI Bus
• Setting TERMPWR
• Confirming the Installation
• Adding an Additional Device
• Using the Loader/Library Interface Connector
Caution: Before you begin, review the safety, ESD, and handling
precautions described in Chapter 2
to avoid personal
injury or damage to equipment.
Comentários a estes Manuais