Quantum LTO 2U Instruções de Operação descarregar pdf (Página 236)

A-4

SCSI REFERENCE 1014826

CHAPTER A—ERROR CODES

Drive Empty The command cannot be

completed because the tape

drive does not contain a

cartridge.

Do one of the following:

 Load a cartridge in the tape drive and retry the

operation.

 If there are two tape drives installed in the

library, select a tape drive that contains a

cartridge and retry the operation.

Drive Full The command cannot be

completed because the tape

drive already contains a

cartridge.

Do one of the following:

 Unload the data cartridge, then retry the

operation. See the Product Manual.

 Wait until the current cartridge is unloaded by

the application, then retry the operation.

 If the library contains two tape drives, retry the

operation on the second tape drive.

Drive Incompatible The detected tape drive is

incompatible with the

library.

Magnum 224, StorageLibrary T24, and

StorageLoader 2U LTO libraries are only

compatible with Ultrium 2 (LTO-2), Ultrium 3

(LTO-3), and Ultrium 4 (LTO-4) tape drives.

Magnum 448 libraries are only compatible with

Ultrium 2 (LTO-2) and Ultrium 3 (LTO-3) tape

drives. Ensure that you have one of these tape

drives installed in the library.

Drive Load Failed The cartridge couldn’t be

loaded into the tape drive

because of a mechanical

problem or because of a

broken tape.

1. Export the tape from the library (see the

Product Manual) and verify that it is in good

condition, then retry the operation. Replace

the cartridge if necessary.

2. If the error persists, contact Tandberg Data

Technical Support or your service provider.

Drive Timeout The tape drive took too long

to load or unload a tape, or

the tape drive is not

responding.

1. If possible, use the operator panel to

unloaded any cartridge that is in the tape

drive (see the Product Manual).

2. Power the library off and back on to reset the

tape drive.

3. If the error persists, contact Tandberg Data

Technical Support or your service provider.

Drive Unload Failed The cartridge couldn’t be

unloaded from the tape

drive because of a

mechanical problem.

1. Power the library off and back on to reset the

tape drive.

2. Retry the unload operation once.

3. If the error persists, contact Tandberg Data

Technical Support or your service provider.

Expired Cleaning Tape The cleaning tape in the

fixed cleaning slot has been

fully used.

Replace the cleaning cartridge with one that is

compatible with this tape drive. Use only LTO

cleaning cartridges with LTO tape drives.

Table A-1 Library LCD error messages (continued)

Error Message Description Corrective Action

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 263 264

Comentários a estes Manuais

Sem comentários