Quantum LTO 2U Instruções de Operação descarregar pdf (Página 233)

JULY 2007 MAGNUM 224, MAGNUM 448, STORAGELIBRARY T24, OR STORAGELOADER 2U

A-1

ERROR CODES

This appendix describes the errors reported by the library. The library uses

two methods for reporting error conditions:

 Errors that occur only when the library is being operated from the operator

panel (Sequential mode), or when the library is performing diagnostics, only

appear on the LCD and are not reported by the REQUEST SENSE

command.

 If the library is operating in Random mode, errors are reported over the

SCSI bus. Some of these errors also appear on the LCD, others do not.

Section A.2 on page A-13 describes errors reported over the SCSI bus are

associated with the sense key data returned by the library in response to a

REQUEST SENSE command (see Chapter 18).

A.1 ERROR MESSAGES DISPLAYED ON THE LCD

A.1.1 LIBRARY LCD ERROR MESSAGES

This section describes the general error messages that can appear on the

library’s operator panel and provides corrective actions.

Caution

Most library components can be replaced only by Tandberg Data-approved service

providers. If you cannot find an obvious cause for the problem, contact your

service provider. Do not attempt to replace any components other than the tape

drive. If you do, you will void your warranty.

! !

! Important

Some corrective actions advise you to reset or power the library

off and back on. To avoid disrupting communication between the

host computer and other devices on the bus, make sure that

there is no activity on the bus before you reset or power off the

library. If you need to power the library off, first unload the

cartridge from the tape drive, if possible, to avoid possible

damage to the cartridge.

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 263 264

Sem comentários

Quantum LTO 2U Instruções de Operação Página 233