Quantum LTO 4 Guia do Utilizador descarregar pdf (Página 37)

Chapter 2 Installation Procedures

Installing the Tabletop LTO-4 (Model B) Half-Height Tape Drive

LTO-4 (Model B) Half-Height Tape Drive User’s Guide 21

• Attach either the SCSI OUT interface cable or a SCSI

terminator to the other parallel SCSI interface connector on

the back of the drive.

If the tabletop LTO-4 (Model B) Half-Height Tape Drive is the

last or only device in a SCSI chain, you must install a 68-pin

low voltage differential (Ultra320 SCSI) terminating plug on

the unused parallel SCSI connector.

See figure 11

for tabletop parallel SCSI bus termination

examples.

Caution: The LTO-4 (Model B) Half-Height Tape Drive with the

parallel SCSI interface is a low voltage differential (Ultra320

SCSI) SCSI device. Install it only in LVD environments.

Plugging an LVD drive into a high voltage differential (HVD)

bus makes the entire bus nonfunctional and may

permanently damage the drive or other SCSI devices on the

bus.

b For the SAS tabletop drive, attach the external SAS interface

cable to the 26-pin SFF-8088 mini-SAS connector on the back of

the drive.

3 Verify that the tabletop LTO-4 (Model B) Half-Height Tape Drive AC

power switch is set to the off position, and connect the AC power

cord to the power connector on the back of the drive.

4 Connect the drive AC power cord to the facility AC power

receptacle.

5 Reconnect the workstation or server system AC power cord to the

facility AC power receptacle.

After connecting the tabletop drive interface and AC power cables,

proceed to Restarting the Tabletop Drive System

in the following

subsection.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 97 98

Sem comentários

Quantum LTO 4 Guia do Utilizador Página 37