Quantum LTO 4 Guia do Utilizador descarregar pdf (Página 34)

Chapter 2 Installation Procedures

Installing the Tabletop LTO-4 (Model B) Half-Height Tape Drive

18 LTO-4 (Model B) Half-Height Tape Drive User’s Guide

Figure 8 Tabletop Parallel SCSI

ID Selector Switch

Note: Parallel SCSI controllers and host adapters generally use ID 7. In

some systems, the boot drive uses ID 0 or ID 1. Avoid

configuring the LTO-4 (Model B) Half-Height Tape Drive to these

SCSI IDs.

After configuring the parallel SCSI ID, proceed to Connecting the

Tabl et op Dr iv e I n t e r f a c e and AC Power Cables in the following

subsection.

Connecting the

Tabletop Drive Interface

and AC Power Cables

As shown in figure 9 and figure 10, the rear panels of the tabletop LTO-

4 (Model B) Half-Height Tape Drives have connectors for:

• Either a 68-pin parallel SCSI cable (two connectors), or a 26-pin SFF-

8088 mini-SAS style interface cable

•The AC power cable

For the tabletop parallel SCSI drive, either SCSI connector can be used as

a SCSI IN or SCSI OUT connection. This means you can use either

connector to attach the drive to a host computer or to another parallel

SCSI device.

Parallel SCSI ID selector switch

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 97 98

Sem comentários

Quantum LTO 4 Guia do Utilizador Página 34