Quantum LTO 4 Guia do Utilizador descarregar pdf (Página 29)

Chapter 2 Installation Procedures

Installing the Internal LTO-4 (Model B) Half-Height Tape Drive

LTO-4 (Model B) Half-Height Tape Drive User’s Guide 13

4 Position the drive in the bay and align either the upper or lower

mounting holes—whichever is appropriate—with the holes in the

chassis (see figure 5

5 Secure the drive using two M3.0 X 3 metric screws on each side.

Caution: Using screws longer than 3 mm can damage the drive.

Do not

use screws longer than 3 mm to secure the internal

LTO-4 (Model B) Half-Height Tape Drive.

After mounting the internal LTO-4 (Model B) Half-Height Tape Drive,

proceed to Connecting the Internal Drive Interface and DC Power Cables

in the following subsection.

Figure 5 Internal Tape Drive

Mounting Hole Locations

Connecting the Internal

Drive Interface and DC

Power Cables

As shown in figure 6, the rear panel of the internal LTO-4 (Model B) Half-

Height Tape Drive has connectors for:

• Either a 68-pin parallel SCSI or a 29-pin SFF-8482 serial-attached

SCSI (SAS) interface cable

• A serial library interface cable

• The internal drive DC power cable

Lower mounting holes

Upper mounting holes

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 97 98

Sem comentários

Quantum LTO 4 Guia do Utilizador Página 29