Quantum LTO 4 Guia do Utilizador descarregar pdf (Página 24)

Chapter 2 Installation Procedures

Installing the Internal LTO-4 (Model B) Half-Height Tape Drive

8 LTO-4 (Model B) Half-Height Tape Drive User’s Guide

Unpacking and

Inspecting the Drive

Although each LTO-4 (Model B) Half-Height Tape Drive is inspected and

carefully packaged at the factory, damage can occur:

• In shipment

• When being unpacked

Observe the handling precautions listed in Handling Precautions and

Installation Guidelines and carefully unpack and inspect the LTO-4

(Model B) Half-Height Tape Drive as follows:

1 Visually inspect the shipping container and notify your carrier

immediately of any damage.

2 Place the shipping container on a flat, clean, stable surface and

carefully remove the contents.

3 Visually inspect the LTO-4 (Model B) Half-Height Tape Drive and

notify your Quantum representative immediately of any damage.

4 Always save the shipping container and packing materials for any

future reshipment.

Installing the Internal LTO-4 (Model B) Half-Height

Ta p e D r i v e

To install the internal LTO-4 (Model B) Half-Height Tape Drive, complete

the following procedures in the order presented:

1 Depending on the interface configuration of the drive:

IF the drive interface is . . . THEN . . .

parallel Small Computer

System Interface (SCSI),

proceed to Configuring the

Internal Parallel SCSI Tape Drive in

the following subsection to

configure the parallel SCSI ID and

bus terminator power.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 97 98

Sem comentários

Quantum LTO 4 Guia do Utilizador Página 24