Quantum LTO 4 Guia do Utilizador descarregar pdf (Página 25)

Chapter 2 Installation Procedures

Installing the Internal LTO-4 (Model B) Half-Height Tape Drive

LTO-4 (Model B) Half-Height Tape Drive User’s Guide 9

2 Connecting the Internal Drive Interface and DC Power Cables on

page 13.

3 Restarting the Internal Tape Drive System

on page 15

4 Installing the LTO Driver Software

on page 23, if required.

5 Registering the LTO-4 (Model B) Half-Height Tape Drive

on page 23.

Configuring the

Internal Parallel SCSI

Ta p e Drive

The factory-set default configuration of the internal parallel SCSI LTO-4

(Model B) Half-Height Tape Drive is:

• SCSI ID: 6

• Terminator power: enabled

Configuring the Internal Drive Parallel SCSI ID

Each device on the parallel SCSI bus must have its own unique SCSI ID.

Use SCSI configuration jumper pins 1–2, 3–4, 5–6, and 7–8 on the drive

serial-attached SCSI (SAS), there is no need to configure the

SCSI ID or bus termination, as SAS

is a point-to-point architecture.

Skip to Mounting the Internal Tape

Drive on page 12

IF the drive interface is . . . THEN . . .

IF the default parallel SCSI

ID configuration is . . .

THEN you can . . .

compatible with your system

SCSI bus,

skip the following subsection and

proceed to Configuring the Internal

Parallel SCSI Terminator Power on

page 10.

already assigned to another

device,

change the configuration of either

the other device, or the LTO-4

(Model B) Half-Height Tape Drive, as

described in the following

subsection.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 97 98

Comentários a estes Manuais

Sem comentários

Quantum LTO 4 Guia do Utilizador Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Unidades de fita magnética Quantum LTO 4