Quantum DLT 2500 Manual de Serviço descarregar pdf (Página 87)

Cleaning

This command moves the tape from slot 0 in the magazine to the drive. In this example,

the argument sc3d6l0 tells the system that the drive is located on SCSI bus 3 and the SCSI

device ID is 6.

To unload a tape from the drive into slot 0 in the stacker’s magazine, enter a command

similar to

% /usr/sbin/stacker -u 0 /dev/scsi/sc3d6l0

This command unloads the tape from the target drive sc3d6l0 (SCSI bus 3 device ID 6)

and puts it into slot 6 in the stacker’s magazine. Note that if there is already a tape in slot

6 of the magazine, the system returns an error message. For more information on these

commands, see the stacker(1M) reference (man) page.

Cleaning

When a drive head is dirty and needs cleaning, or the data cartridge is bad, the Use

Cleaning Tape LED lights on the DLT2000XT drive or the HC message appears on the

DLT2500XT stacker OCP.

To clean a drive, use only an approved cleaning cartridge (see Figure 5-8). You can use a

DLT2000XT cleaning cartridge approximately 20 times before you must replace it. The

cleaning cartridge and data cartridges are always different colors.

Figure 5-8 Cleaning Cartridge

Cleaning Tape III

Check box after each use.

Discard cleaning cartridge after final use.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 113 114

Sem comentários

Quantum DLT 2500 Manual de Serviço Página 87