Quantum DLT 2500 Manual de Serviço Página 50

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 114
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 49
34
Chapter 3: Installing the Desktop DLT2000XT Tape Drive
Connecting the Desktop DLT2000XT Tape Drive to the Host
To connect your desktop DLT2000XT tape drive to the host system, follow these steps:
1. Power off the host system.
2. Plug one end of the SCSI cable into the hosts external single-ended SCSI connector.
If you are not sure of the location of the single-ended SCSI connector, consult the
owners guide.
3. Plug the other end of the SCSI cable into the leftmost SCSI connector on the back of
the desktop DLT2000XT tape drive. Figure 3-2 shows an example.
Note: Always plug the incoming SCSI cable into the leftmost SCSI connector on the
back of the unit. The right side connector should be used for termination.
Figure 3-2 SCSI Connection to a Deskside Host System
Digital Linear Tape
unit
Challenge L or
Onyx deskside
system
68-pin to 68-pin
SCSI cable
5
Vista de página 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 113 114

Comentários a estes Manuais

Sem comentários