Quantum DLT 2500 Manual de Serviço descarregar pdf (Página 56)

Chapter 3: Installing the Desktop DLT2000XT Tape Drive

Installing the SCSI Patch

Once you have installed the DLT2000XT tape drive in the chassis, load the CD supplied

with the tape drive. Follow information in the release notes for which patches to install

for your system; install the patch(es) with the Inst utility.

Powering Off Your Desktop DLT2000XT Tape Drive

To power off the tape drive, follow these steps:

Caution: Do not shut down the DLT2000XT tape drive until you are certain that nobody

is logged in and accessing ﬁles stored on the DLT2000XT tape drive, or unless there is an

emergency and you must turn off the system immediately.

1. Always shut down the host system before powering off the desktop DLT2000XT

tape drive.

2. Always remove the tape cartridge from the DLT2000XT tape drive before turning

off power to the drive.

3. Use only the power switch located at the rear of the desktop DLT2000XT tape drive

to shut down the system.

Facing the back of the desktop DLT2000XT chassis, press in on the “O” side of the

rocker switch (see Figure 3-5). The power turns off and the desktop DLT2000XT

tape drive’s front LEDs goes dark.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 113 114

Sem comentários

Quantum DLT 2500 Manual de Serviço Página 56