Quantum DLT 2500 Manual de Serviço descarregar pdf (Página 68)

Chapter 4: Installing the DLT2500XT Stacker

Powering Off Your DLT2500XT Stacker

To power off the tape drive, follow these steps:

Caution: Do not shut down the DLT2000XT tape drive until you are certain that nobody

is logged in and accessing ﬁles stored on the DLT2000XT tape drive, or unless there is an

emergency and you must turn off the system immediately.

1. Always shut down the host system before powering off the desktop DLT2000XT

tape drive.

2. Always unload the tape cartridge from the DLT2500XT stacker drive and conﬁrm

that it is back in the stacker’s magazine before turning off power. If you need to

remove the stacker’s magazine, follow the instructions in “Tape Magazine

Operation” in Chapter 5 before turning off power.

3. Use only the power switch located at the rear of the DLT2500XT stacker to shut

down the system.

4. Facing the back of the DLT2500XT chassis, shut it off by pressing on the “O” side of

the on/off switch (see Figure 4-5). The power turns off, and the DLT2500XT

stacker’s front LEDs go dark.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 113 114

Sem comentários

Quantum DLT 2500 Manual de Serviço Página 68