Quantum DLT 2500 Manual de Serviço descarregar pdf (Página 54)

Chapter 3: Installing the Desktop DLT2000XT Tape Drive

Using the Power-On Self Test

The power-on self test starts automatically on power-on. Observe the LEDs on the front

panel, making sure that they light in the following order:

1. All LEDs on the right front panel light sequentially from top to bottom as the POST

begins. The LEDs remain on for a few seconds.

2. All LEDs on the left front panel light simultaneously for about three seconds, and

then turn off.

3. The green Operate Handle, the orange Write Protected, and the yellow Use

Cleaning Tape LEDs turn off. The yellow Tape in Use LED blinks as the tape drive

initializes.

4. After initialization, if no tape cartridge is loaded, the yellow Tape in Use LED turns

off, the green Operate Handle LED turns on, the handle unlatches, and the beeper

sounds.

Figure 3-6 shows the LEDs on the front panel.

Figure 3-6 DLT2000XT Desktop Front Panel

The power-on self test takes about 15 seconds. However, the media might require more

time to become ready for use.

Write Protected LED

Tape in Use LED

Operation Handle LED

Unload button

Tape load door

Load/unload handle

Use Cleaning Tape LED

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 113 114

Sem comentários

Quantum DLT 2500 Manual de Serviço Página 54