Quantum DLT VS160 Manual do Utilizador descarregar pdf (Página 73)

Diagnostics and Troubleshooting

Removing Stuck Cartridges

Quantum ATL ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 59

2 Remove the power cable and SCSI cables from their connectors

on the back panel of the ValueLoader.

3 Remove the ValueLoader from its rack slot, if applicable, and

place it on a table or other clear work surface.

4 Use a screwdriver to remove the front cover screws that secure

the mounting brackets (if the ValueLoader is rackmounted)

from both sides of the ValueLoader, as shown in figure 15

Figure 15 Removing

Mounting Brackets

(Left Side Shown)

5 Remove the five screws on the back of the ValueLoader, and

two additional screws, one on each side of the ValueLoader, to

loosen the ValueLoader cover.

6 Remove the top cover by lifting it from the back and easing it

out from under the front panel display cover.

Warning: To prevent injury, disconnect the power and SCSI

cables before removing the ValueLoader cover

and keep fingers away from the fan.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 89 90

Sem comentários

Quantum DLT VS160 Manual do Utilizador Página 73