Quantum DLT VS160 Manual do Utilizador descarregar pdf (Página 28)

Installing the ValueLoader

Preparing the Host and Verifying the Connection

14 Quantum ATL ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual

6 Plug the power cable into the nearest properly grounded

power outlet.

7 Plug in the host server or workstation and all attached devices.

8 Turn on the ValueLoader by setting the power switch on the

front panel to the ON position. Turn on any other devices you

turned off earlier. Check the LCD display to make sure the

ValueLoader is receiving power. If it is not, check the power

connectors and your power source.

During the Power-On Self Test (POST), all four LEDs are

illuminated briefly, followed by just the Ready/Activity LED

flashing. When the initialization sequence is complete, the LCD

screen displays the Home screen.

9 Turn on the server.

Preparing the Host and Verifying the Connection 1

If necessary, install a SCSI host adapter, software, and compatible

driver(s). Refer to the manuals for the host computer and the SCSI

host adapter for detailed instructions. In addition, follow these

general guidelines:

• When the host server is powered on, install software, and/or

driver(s) that are compatible with the ValueLoader. (See

Installing the Device Drivers

on page 16 for more information.)

Software compatibility information is available at

www.quantum.com. Most backup software packages require an

additional module to communicate with the ValueLoader

robotics.

• If the host server is connected to a network, check with the

system administrator before turning off power.

Note: To disconnect all power from the ValueLoader,

remove the power cord from the outlet.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 89 90

Sem comentários

Quantum DLT VS160 Manual do Utilizador Página 28