Quantum DLT VS160 Manual do Utilizador descarregar pdf (Página 27)

Installing the ValueLoader

Connecting the SCSI and Power Cables

Quantum ATL ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 13

3 Attach the other end of the SCSI cable to the connector on the

SCSI host adapter or to the connector on the previous device on

the SCSI bus.

4 Attach the terminator to the remaining SCSI connector on the

rear panel of the ValueLoader (if the ValueLoader is the last or

only device on the SCSI bus). Otherwise, attach the cable to the

next device on the SCSI bus. Make sure that the last device on

the SCSI bus is properly terminated.

5 Attach the female connector on the power cable to the power

connector on the rear panel of the ValueLoader.

Figure 8 Attaching

SCSI and Power

Cables

Note: If the supplied SCSI cable does not fit the connector

on your SCSI host adapter, you either have an

incompatible SCSI host adapter or you need to

purchase a cable adapter. Contact your service

representative or your SCSI host adapter

manufacturer for information.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 89 90

Sem comentários

Quantum DLT VS160 Manual do Utilizador Página 27