Quantum DX30 Guia do Utilizador descarregar pdf (Página 71)

Chapter 3 DX-Series Remote Management

Configuration

Quantum DX-Series User’s Guide 53

Figure 32 Device

Mapping Configuration

The Device Mapping page allows you to map or assign DX-Series

virtual devices (robot and tape drives) to specific Fibre Channel

ports. The default setting for both the DX30 and DX100:

• Port 5 is assigned the robot and tape drives 0 through 2.

• Port 6 is assigned tape drives 3 through 5.

5 There are two ways to assign virtual devices to a specific Fibre

Channel port:

a Click Auto Populate to allow the DX-Series controller to

automatically assign virtual devices to a Fibre Channel port. The

controller assigns a robot and partition to each port.

Example: A system with 1 partition would have a robot assigned

to LUN 0 and all other devices within that partition assigned to

additional LUNs on that port.

b Use the drop down boxes located under the port number to select

the devices mapped to that port. Do NOT assign the same device

to more than one port unless your backup application can

support multiple mappings of the same device to more than one

port.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 157 158

Sem comentários

Quantum DX30 Guia do Utilizador Página 71