Quantum DX30 Guia do Utilizador descarregar pdf (Página 123)

Chapter 4 Troubleshooting

Host Bus Adapter Settings

Quantum DX-Series User’s Guide 105

9 Enter 1 for 1 Gig Fibre Channel HBAs or 2 for 2 Gig Fibre Channel

HBAs in the

New Value edit box, check both the Permanent and Global

check boxes, and click

Change.

Q-Logic™ Fibre

Channel HBA

For the DX-Series system to communicate with the Q-Logic Fibre

Channel HBA, the card must be setup correctly.

To setup the Q-Logic Fibre Channel HBA:

1 Power on the host containing the Q-Logic HBA.

2 As the host boots, watch for the Q-Logic prompt that tells you to

press <Control> Q to enter the HBA setup utility.

3 Under Configuration Settings, select Host Adapter Settings.

4 Under Host Adapter Settings, set the frame size to 2048.

5 Under Extended Firmware Settings, set the type of connection to #2

loop preferred, otherwise point-to-point.

Note: The default setting is 0 for auto speed selection. This

setting should NEVER be used. This could cause the HBA

to fail to initialize.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 157 158

Sem comentários

Quantum DX30 Guia do Utilizador Página 123