Quantum DX30 Guia do Utilizador descarregar pdf (Página 117)

Chapter 4 Troubleshooting

Host Bus Adapter Settings

Quantum DX-Series User’s Guide 99

Fibre Channel

Network Problems

Table 24 describes corrective actions for problems occurring with the

Fibre Channel network.

Table 24 Fibre

Channel Network

Problems

Host Bus Adapter Settings 4

This section provides additional information on setting up your specific

Fibre Channel HBA (Host Bus Adapter).

The following HBAs have specific configuration information that must be

set properly to function with the DX-Series system. Refer to your specific

HBA documentation for additional information.

Problem Corrective Action

The Fibre Channel

link lights on the

DX-Series controller

are not lit when a

cable is connected to

a hub or switch.

Check to make sure the Fibre Channel

cable is not damaged: Replace the cable.

Fibre Channel controller, switch, or hub is

damaged.

Windows cannot see

the robot or tape

drives with JNI Fibre

Channel HBA.

See Host Bus Adapter Settings

for HBA

information.

Windows cannot see

the robot or tape

drives with Emulex

Fibre Channel HBA.

See Host Bus Adapter Settings

for HBA

information.

Tech Tip: If your Fibre Channel HBA supports bus resets, this

feature must be disabled to operate with the DX-Series

controller. Fibre Channel HBAs only support bus resets.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 157 158

Comentários a estes Manuais

Sem comentários

Quantum DX30 Guia do Utilizador Página 117

Comentários a estes Manuais