
Appendix C Automatic Drive Cleaning
Selection of Cleaning Mode
96 ATL P2000 Series Automated Tape Library User’s Guide
• Tracking and selecting cleaning cartridges
• Moving a cleaning cartridge to the drive
• Determining when a cleaning cartridge has used all 20 of its
available cleaning cycles
• Moving used up cartridges to the load port
Selection of Cleaning Mode
3
The cleaning mode is selectable from:
• The diagnostic software
• The touch screen GUI
• A Mode Select command
The default cleaning mode is host-initiated. A Mode Select
command permanently changes the cleaning mode in the library’s
NVRAM, and is retained if the library power is cycled.
Diagnostic
Software
3
To change automatic cleaning mode from the diagnostic software
select
Config
:
• Enable clean tape
- turns automatic cleaning mode on
• Disable clean tape
- turns automatic cleaning mode off
Touch Screen GUI
3
To change automatic cleaning mode from the touch screen GUI,
select
Configuration/AutoClean
:
• Enable
- turns automatic cleaning mode on
• Disable
- turns automatic cleaning mode off
Comentários a estes Manuais