Quantum L200 Guia do Utilizador descarregar pdf (Página 35)

Chapter 2 Installing the Library

Configuring the Library

Quantum|ATL PowerStor L200 Series Library User’s Guide 19

If all the POST tests are completed successfully, and the drive and

library are initialized, the library is ready for operation. If the tests

did not complete, run the POST again; if the tests are still not

complete, the library needs service.

Configuring the Library 2

Configuration consists of verifying that the library and the internal

drive have the correct SCSI ID settings. The system uses SCSI IDs

to identify or address devices, such as the library controller and the

tape drive on the SCSI bus.

If the library is one of multiple SCSI devices on the bus, be sure to

use a SCSI ID that is unique from any other device or system ID on

the SCSI bus (see table 2

Table 2 SCSI ID

Default Settings

Verifying the SCSI

Settings

To view the current SCSI ID settings using the OCP (see figure 1

1 Press Select until the message SCSI ID? is displayed.

2 Press Next to enter the SCSI ID menu and display the message

View ID?.

3 Press Enter to view all the SCSI IDs.

Note: To rerun the POST, turn off the library. Wait ten seconds,

then turn the library power on again.

SCSI ID Device

1Tape drive

0 Library controller

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 111 112

Sem comentários

Quantum L200 Guia do Utilizador Página 35