
Chapter 3 Quantum PX720 Remote Management
Setup
Quantum PX720 User’s Guide 147
3 Click Reset to return the library to its original settings.
Unload drives
automatically
When enabled, the library will automatically send
an unload command to the drive prior to the
application moving the cartridge back to a bin.
Note: This option should be enabled if the
application does not issue the unload command to
the drive prior to sending the move command.
Return drive
serial numbers
to host
When enabled, the tape drive automatically
returns the serial number for each tape drive to
the host.
Identify as ATL
P7000
When enabled, an identifier of ATL P7000 will be
included in the inquiry message sent to the host.
Changing the library identification requires
activation.
Prefix media
type in barcode
Enables/disables swapping media type prefix
from the back of barcode to the beginning.
Barcode length
Configures the number of maximum characters of
tape cartridge barcode label to return to the host;
valid values are 1 through 9; 0 indicates to return
all characters in the barcode.
Configured
Drives
Only available in a NON-partitioned library.
Enter the number of configured drives and click
Apply. Click Activate to reconfigure the library
with the new drive count. The default number of
configured drives is the number of potential drive
bays within the cabinet. This number may exceed
the actual number of installed tape drives.
Configured
Slots
Only available in a NON-partitioned library.
Enter the number of configured slots and click
Apply. Click Activate to reconfigure the library
with the new slot count. This will be the number
of slots available and reported to the host.
Field Description
Comentários a estes Manuais