Quantum PX720 Guia do Utilizador descarregar pdf (Página 167)

Chapter 3 Quantum PX720 Remote Management

Setup

Quantum PX720 User’s Guide 144

and/or second values using the up and down arrows, click on

the desired field, then click the up and down arrow to change the

value by 1. Double-clicking will increment or decrement the

value by 5. You may also type in a valid hour (0 - 23), minute (0-

59), or second (0-59). Use the scroll list to select the correct time

zone.

b To automatically adjust for daylight savings time, select the

checkbox to automatically adjust for daylight savings time. You

can customize the starting and ending period for

Daylight Saving

Time

by using the appropriate pull-down options to set the start

and end period.

c Select Use NTP (Network Time Protocol) to synchronize the

Quantum PX720 system clock with an outside time server. To set

the date and time using a network server, select NTP server

check box and enter an NTP server. Click

Test NTP to verify the

NTP Server.

3 Click Save when complete.

The Quantum PX720 will not use the new date and time zone

information until it has been rebooted. The

Reboot button is available

at the bottom of the page.

Library 3

The library configuration section allows the user to configure automatic

library settings.

1 To access the Library page, from the Setup page, click on the Library

tab at the top of the page.

The Library page displays (see figure 85).

Note: The default starting and ending times are automatically

selected when changing time zone.

Note: The library must be offline to change the library settings.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 258 259

Sem comentários

Quantum PX720 Guia do Utilizador Página 167