Quantum DLT 4000 Manual descarregar pdf (Página 286)

100

101

Appendix D: The Tape Cartridge

D-6 Quantum DLT 4000 Tape Drive

6. Ensure that the tape leader within the tape cartridge is in the correct

position. To do this, you must open the tape cartridge door. Refer to Figure

D-3.

Figure D-3 Opening the Door on a DLTtape Cartridge Showing Tape Leader Loop in its

Correct Position

Open the door by holding the DLTtape cartridge as shown in Figure D-3.

On the right side corner of the tape cartridge there is a small tab in a cut-out

portion of the cartridge. Using your thumb, gently lift up on the tab and swing the

door open (Figure D-3).

Inside the door, you will see the tape and cartridge leader loop. The loop should

stick up about an eighth of an inch when viewed from the edge; the loop must be

a closed loop. If the loop is torn, bent, pulled in, or not sticking up about an eighth

of an inch, do not use the tape cartridge.

Leader

Loop

1 2 ... 281 282 283 284 285 286 287 288 289 290 291 ... 299 300

Comentários a estes Manuais

Sem comentários

Quantum DLT 4000 Manual Página 286

Comentários a estes Manuais

Manuais e produtos relacionados com Unidades de fita magnética Quantum DLT 4000