Quantum DLT 4000 Manual descarregar pdf (Página 22)

About This Manual

Quantum DLT 4000 Tape Drivexxii

Chapter 2 Hardware Implementation

This chapter contains configuration and installation information for the

tape drive, descriptions of the drive controls and LEDs, and information

on running the self-test.

Chapter 3 SCSI Description

This chapter provides a detailed description of the logical interfaces of

the tape drive. It describes the products’ compliance with the ANSI

SCSI-2 specification. The drive’s many optional features are described

here and throughout the manual.

Chapter 4 Messages

This chapter provides a list and description of most messages supported

by the tape drive. The SCSI message system allows communication

between SCSI initiators and SCSI targets (the tape drive, in this case)

for interface management and for command elaboration and

qualification.

Chapter 5 SCSI Commands

This chapter describes in detail each command supported by the tape

drive. The SCSI command system enables an initiator to direct a tape

drive to perform a wide range of operational and diagnostic functions.

This chapter also provides sense key information for the REQUEST

SENSE SCSI command.

Appendix A Definition of Vendor Unique Sense Data Information

Appendix A provides a list of internal status codes related to the

REQUEST SENSE SCSI command.

Appendix B EEPROM-Resident Bugcheck and Event Logs

Appendix B provides an explanation of the error and event logs stored in

semi-permanent, non-volatile memory.

Appendix C Updating the Firmware

Appendix C provides a step-by-step procedure for updating a tape drive’s

PCBA controller-resident firmware.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 299 300

Sem comentários

Quantum DLT 4000 Manual Página 22