
Diagnostics and Troubleshooting
ValueLoader Error Codes
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 57
Table 5 Error Codes
Error Code Description Details
3081
Invalid Command Error. This error indicates that the ValueLoader
received an undefined command or an invalid
parameter with a command.
3082
Device Status Not Suitable To
Execute This Command.
If the robotics are busy, some commands
cannot be executed at the same time. This error
indicates a probable violation. This is not an
error condition, but it does result in
busy being
reported to the host for the requested SCSI
command.
3083
Inventory Not Valid. The cartridge inventory is not valid because of
manual changes or previous fatal errors.
Update the inventory using the
Re-inventory
option in the
Configuration menu (see Creating
an Inventory of Cartridges on page 32) or
power cycle.
3084
Source Empty. There is no cartridge in the location from which
a cartridge move was issued.
3085
Destination Full. The location to which a cartridge move was
issued already contains a cartridge.
3086
Import/Export Slot Access
Rejected.
User attempted to access the Import/Export
slot, but media removal was prevented by the
host.
3087
Operation Timeout. A command did not complete in the required
amount of time.
3088
Communications Error
During Loop-back.
Power cycle the ValueLoader and attempt the
operation again. If the error recurs, contact
Quantum Technical Support.
3089
System Test Timeout. There was a communication timeout between
the drive and loader during the System Test.
Comentários a estes Manuais