Quantum FastStor 2 Guia do Utilizador descarregar pdf (Página 37)

Resetting the Autoloader 37

Managing the Autoloader

This section discusses managing the autoloader, including resetting the autoloader, setting SCSI

IDs, setting the autoloader mode, and updating firmware. You can also use the System Test (see

Using System Test) and the information retrieval tool (see Retrieving Information) to manage the

FastStor 2.

Resetting the Autoloader

This option resets the autoloader robotics and the tape drive within the autoloader, forces a new

cartridge inventory, and clears any current error condition.

To reset the autoloader

1. From the Home Screen or main menu, press + or – until Configuration appears on the top line

of the LCD screen.

2. Press ENTER to select.

3. Press + or – until the Reset message appears on the LCD screen.

4. Press ENTER to reset the autoloader.

After initialization, the autoloader returns to normal operation and displays the Home screen.

Viewing or Changing the SCSI IDs

Use this option to view or change the SCSI IDs used by the autoloader. The autoloader occupies

two SCSI IDs, one ID is assigned to the autoloader and the second ID is assigned to the tape drive.

The default SCSI ID for the autoloader's SCSI controller is 0. The default SCSI ID for the tape drive

is 5. You only need to change a SCSI ID if there is another device, or devices, already assigned to

these IDs.

NOTE:

This option is primarily used if the autoloader is in an error state.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 67 68

Sem comentários

Quantum FastStor 2 Guia do Utilizador Página 37