
Chapter 3 Installing External Tape Drives
Installation Summary
DDS-4/DAT 72 User’s Guide 37
Installation Summary 3
The following steps summarize the installation procedure for your
external tape drive.
1 Verify the Drive’s Default Settings
2 Record Your Drive’s Information
3 Attach a SCSI Interface Cable
4 Terminate the SCSI Bus, if Necessary
5 Attach a Power Cable
6 Complete and Verify Your Installation
Reviewing Drive Default Settings 3
Your external tape drive comes with various default settings. You may
need to change these settings to suit your requirements. Review the
default settings in
table 5 to determine whether they suit your
requirements or need to be changed.
• If you do not need to change these default settings, proceed to
Connecting a SCSI Cable
.
Note: These settings can be changed by accessing the switches
located on the bottom of the drive. Turn the drive over and
gently pull the tab on the access door to release it. Once the
door is open, the switches will be accessible. See figure 4
on
page 15 for details about the switch settings.
Comentários a estes Manuais