Quantum Scalar 100 Guia do Utilizador descarregar pdf (Página 46)

42 Maintenance

Ethernet Test

1 Obtain the Ethernet network parameters for the SNC 6101.

For more information, refer to To configure the SNC 6101

on page 22.

2 Attach the Ethernet loop back plug to the Ethernet port.

3 From the service terminal, enter the elTest command.

4 If the test passes, go to Step 5

5 Remove the Ethernet loop back plug.

Network Setup for the SNC 6101

The SNC 6101 must be connected to a 10/100-base-T Ethernet network for use with the ADIC Management

Console software. For more information, refer to the ADIC Management Console User Guide.

Configuring network parameters requires access to the SNC 6101 service port. Complete procedures for

setting these values are provided in To configure the SNC 6101

on page 22.

Updating the SNC 6101

1 From the service terminal, enter the normalBoot command.

2 Wait until the SNC 6101 has finished booting.

3 From the service terminal, enter the version command.

4 Write down the operating software version number.

5 Determine whether the SNC 6101 firmware version requires an update.

If an update is required, download the new file or files and the associated readme file. You will install

the new firmware as you complete the Post-Repair Checklist

on page 43.

6 If you replaced the SNC 6101, enter the ridTag command and type the identifier.

7 Power down the SNC 6101 and the Scalar 100.

8 Unplug the AC power cord.

9 Disconnect the RS-232 cable from the SNC 6101 service port.

10 Proceed to Post-Repair Checklist

on page 43.

Note

Ethernet port “2” is disabled internally. Omit testing of this port.

Note

Use the sysVpdShow command to obtain the required identifier from the

original SNC 6101. The ridTag command does not need to be used for

replacement units obtained from the factory.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

Sem comentários

Quantum Scalar 100 Guia do Utilizador Página 46