Quantum Scalar 100 Guia do Utilizador descarregar pdf (Página 27)

SNC 6101 User’s Guide 23

3 After entering the initializeBox command, enable the following SNC 6101 features:

a. Data Mover

sncFeatureEnable "enable"

b. Scalar Firewall Manager

sfmFeaturEnable "enable"

4 Verify your cable connections from the SNC 6101 to SCSI devices by typing scsiShow.

A typical response would be:

========================================

Ultra2/3 SCSI Initiator Channel 1: 1030 - 0x10f77000 HostId=7 AltId=Auto

ID LUN Vendor Product Rev | Min Sync Period / Offset Width

--------------------------------------|---------------------------------

0 0 IBM SCALAR 100 2.86 | 0 - Unknown Transfer Rate / 0

1 0 IBM ULTRIUM-TD2 3434 | 9 - Ultra160 / 31 16 S W

========================================

Ultra2/3 SCSI Initiator Channel 2: 1030 - 0x10f5d000 HostId=7 AltId=Auto

ID LUN Vendor Product Rev | Min Sync Period / Offset Width

--------------------------------------|---------------------------------

2 0 IBM ULTRIUM-TD2 3434 | 9 - Ultra160 / 31 16 S W

3 0 IBM ULTRIUM-TD2 3434 | 9 - Ultra160 / 31 16 S W

========================================

Ultra2/3 SCSI Initiator Channel 3: 1030 - 0x10fab000 HostId=7 AltId=Auto

ID LUN Vendor Product Rev | Min Sync Period / Offset Width

--------------------------------------|---------------------------------

4 0 IBM ULTRIUM-TD2 3434 | 9 - Ultra160 / 31 16 S W

5 0 IBM ULTRIUM-TD2 3434 | 9 - Ultra160 / 31 16 S W

========================================

Ultra2/3 SCSI Initiator Channel 4: 1030 - 0x10f91000 HostId=7 AltId=Auto

ID LUN Vendor Product Rev | Min Sync Period / Offset Width

--------------------------------------|---------------------------------

8 0 IBM ULTRIUM-TD2 333K | 9 - Ultra160 / 31 16 S W

========================================

where

• SCSI Initiator Channel identifies each of the four SCSI ports on the SNC 6101 (SCSI 1

- SCSI 4)

• ID is the SCSI address of the device connected to that port

• Product identifies the device located at that address

Note

If the value = 1 = 0x1 message is displayed following a feature enable

command, the license is installed and the feature already enabled. If a value

= -1 is returned, the current license does not support that feature. Use the

command licenseShow for a list of features currently licensed for your SNC

6101. Refer to your SNC Firmware 4 User’s Guide for additional information

about these commands. If the Scalar Firewall Module/Virtual Private SAN or

Data Mover are not listed, contact your ADIC representative for a new license

key.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Comentários a estes Manuais

Sem comentários

Quantum Scalar 100 Guia do Utilizador Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Quantum Scalar 100