Quantum DAT 160 Guia do Utilizador descarregar pdf (Página 37)

Chapter 3 Installing External Tape Drives

Completing Your Installation

Quantum DAT 320 User’s Guide 22

Completing Your Installation

To complete and test your external tape drive installation:

1 Reconnect the power cord to the computer’s power connector.

2 Use the On/Off Switch on the back of the external tape drive to turn

on the drive (see Figure 9

). The Ready LED should be ON, the other

three front-panel LEDs should be

OFF.

3 Turn on the computer.

4 If necessary install the DAT320 O/S driver.

5 Install your backup software program. The documentation that

came with your software should describe this procedure.

6 Gently insert a tape cartridge into the external tape drive’s slot. Slide

the cartridge into the slot until the drive accepts the cartridge and

loads it. A brief delay occurs while the drive identifies the cartridge

type and state, and moves the tape to the data area. Then the green

Ready LED goes ON.

7 Use your backup software application to perform a sample backup-

and-verify operation. The green Ready LED flashes as data is written

to and/or read from the tape.

8 At the end of the operation, press the

Eject button on the front of

the external tape drive to eject the cartridge from the drive.

If you encountered any problems during this procedure, see Chapter 5,

Troubleshooting for troubleshooting procedures.

Registering Your Tape Drive

After you install the tape drive, be sure to register it. Registering your

drive ensures that you will receive the latest information about your

drive, as well as other product, service, and support information. For

your convenience, you can register your drive through our Web site.

•Please visit www.quantum.com/registration

to register your

product.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 63 64

Sem comentários

Quantum DAT 160 Guia do Utilizador Página 37