Quantum DAT 160 Guia do Utilizador descarregar pdf (Página 32)

Chapter 2 Installing Internal Tape Drives

Completing Your Installation

17 Quantum DAT 320 User’s Guide

Completing Your Installation

To complete and test your internal tape drive installation:

1 Use the screws you removed earlier to secure the drive in place.

2 Replace the computer cover.

3 Reconnect the power cord to the computer’s power connector.

4 Turn on the computer.

5 If necessary install the DAT320 O/S driver.

6 Install your backup software program. The documentation that

came with your software should describe this procedure.

7 Gently insert a tape cartridge into the internal tape drive’s slot (see

Loading a Cartridge

on page 29). Slide the cartridge into the slot

until the drive accepts the cartridge and loads it. A brief delay

occurs while the drive identifies the cartridge type and state, and

moves the tape to the data area. Then the green Ready LED goes

ON.

8 Use your backup software application to perform a sample backup-

and-verify operation. The Ready green LED flashes as data is written

to and/or read from the tape.

9 At the end of the operation, press the

Eject button on the front of

the internal tape drive to eject the cartridge from the drive (see

Unloading a Cartridge

on page 30).

If you encountered any problems during this procedure, see Chapter 5,

Troubleshooting for troubleshooting procedures.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 63 64

Sem comentários

Quantum DAT 160 Guia do Utilizador Página 32