Quantum 1200 Series DAT Autochanger Manual do Utilizador descarregar pdf (Página 53)

SDLT 600 Product Manual 37

Chapter 3

3Installing Your

Tape Drive

This chapter describes how to install the SDLT 600 tape drive. This

includes configuration jumper settings, connector pin assignments,

installation instructions, power and signal cabling descriptions, and

operating instructions. This chapter also includes information on

configuring and connecting the tabletop version of the tape drive into a

system.

This chapter covers the following topics:

• Warranty Note

provides a general reminder of certain precautions to

follow so that you do not void your warranty.

• Safety, Handling, and ESD Protection

describes appropriate

safeguards to use when working with the SDLT 600 tape drive

system.

• Pre-Installation Guidelines

describes proper steps to take before

installing the tape drive in a system. This includes recording the

model and serial numbers, and checking that the proper SCSI (or

Fibre Channel) controller and cable have been delivered.

• Configuring and Installing an Internal Tape Drive with SCSI

Interface describes how to configure and install an internal tape drive

with the SCSI interface into a system.

• Configuring and Installing an Internal Tape Drive with Fibre

Channel Interface describes how to configure and install an internal

tape drive with the Fibre Channel interface into a system.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 141 142

Sem comentários

Quantum 1200 Series DAT Autochanger Manual do Utilizador Página 53