Quantum FC420 Guia do Utilizador descarregar pdf (Página 23)

Quantum ATL M2500 Library User’s Guide Addendum—Prism FC420 Bridge Option

Document 6473031-01, Ver. 1, Rel. 1

August 2002

Prism FC420 Services Software Commands 23

SaveConfiguration

(Immediate)

Save the new configuration. If a

firmware restart is required to make

the change, the user is prompted to

confirm the restart. The user can

override the confirmation request by

indicating the override value on the

command line.

saveconfiguration < restart |

nonrestart >

ScsiInitID

Specify the SCSI initiator ID to be used

on the specified SCSI port.

0x07 set scsiinitid [sb [0-15]]

get scsiinitid [sb]

ScsiPortBusSpeed

Specifies the transfer rate at which the

Fibre bridge will attempt to negotiate

with SCSI devices. The choices are Fast

SCSI, Ultra SCSI, Ultra 2 SCSI, and

Ultra 3 SCSI.

ultra3 set scsiportbusspeed

[portnumber [fast | ultra |

ultra2 | ultra3]]

get scsiportbusspeed

[portnumber]

ScsiPortList

(Immediate)

List the available SCSI ports and their

status.

scsiportlist

ScsiPortReset

(Immediate)

Resets the specified SCSI bus. scsiportreset [sb]

ScsiPortResetOnStartup

Specify whether the SCSI port should

be reset on power-up.

enabled set scsiportresetonstartup [sb

[enabled | disabled]]

get scsiportresetonstartup [sb]

ScsiPortSelTimeout

Show the time (msec) that the bridge

waits for a response from a SCSI

device on the selected port after a

selection request.

256 msec set scsiportseltimeout [sb [256

| 128 | 64 | 32 | 16 | 8 | 4 | 2

| 1]]

get scsiportseltimeout [sb]

ScsiPortSyncTransfer

Specify whether synchronous SCSI

transfers should be negotiated with

devices on the specified SCSI port.

enabled set scsiportsynctransfer [[sb]

[enabled | disabled]]

get scsiportsynctransfer [sb]

ScsiPortTaggedQueuing

Specify whether tagged command

queuing is allowed on the SCSI port.

disabled set scsiporttaggedqueuing [sb

[enabled | disabled]]

get scsiporttaggedqueuing

[sb]

ScsiPortWideTransfer

Specify whether wide SCSI transfers

should be negotiated.

enabled set scsiportwidetransfer [sb

[enabled | disabled]]

ScsiTargets

List the SCSI devices that are on the

referenced SCSI bus.

get scsitargets [sb]

ScsiTermination

Set the internal termination of the

referenced SCSI port.

enabled set scsitermination [sb

[enabled | disabled]]

get scsitermination [sb]

Command Description Default Syntax

1 2 ... 18 19 20 21 22 23 24 25 26

Comentários a estes Manuais

Sem comentários