Quantum ACL 452 Guia de Instalação descarregar pdf (Página 55)

Appendix B Supplemental Installation Procedures

Loading the Library with Cartridges

ACL 4/52 Facilities Planning and Installation Guide 39

Loading the Library with Cartridges

Note: The “Auto-Load” feature must be “Enabled” before performing this

procedure. If this feature is not currently Enabled, refer to

“Enabling/Disabling the Auto-Load Feature” on page 36.

Caution: Examine all cartridges before loading them into the library

or tape drive. Look for label stock or other foreign material

that may be clinging to the cartridges.

With the SDA displaying

System On-line

, press and release the

load port OPEN

button and verify that the indicator begins

blinking. (After several seconds, the load port door will

automatically open.)

Warning: Mechanical hazards could be exposed when the load port is

partially open or closed. Do not attempt to insert hands or

fingers into the load port opening at any time.

With the load port door open, place up to four cartridges in the

available load port bins.

Press and release the

load port CLOSE

button.

Warning: The load port door is LOCKED in the “open” position. You

must press and release the CLOSE button before

attempting to close the load port door.

When the

Indicator (LED at the upper left corner of

button) is steadily lit, push the Load Port door closed. (The

library will lock the door.)

Repeat Steps 1 through 4 until you have loaded a maximum of 48

DLT™ cartridges into the library.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Sem comentários

Quantum ACL 452 Guia de Instalação Página 55