Quantum 1200 Series DAT Autochanger Guia do Utilizador descarregar pdf (Página 11)

Quantum Bezel Replacement Guide

Document 81-81252-05 A01

October 2006

DLT VS160/DLT-V4 Bezel Replacement 0

Tool Needed 0 Small flat-head screwdriver or similar tool.

Remove the Existing Bezel 0 1 Place the tape drive on its left side.

2 Hold the right side of the bezel. Press down gently on the right bezel tab

(through the tab slot) while pulling the bezel away from the tape drive

(see figure 1

Figure 1 VS160/DLT-V4

Removal

3 Remove the bezel from the tape drive. Verify that the door spring is still

in place on the bezel.

Note: The tape drive and bezel may look different from the illustration.

The illustration shows an DLT VS160 tape drive.

Caution: Do not use anything that could break off inside the tape

drive (like a pencil tip). Use a small flat-head screwdriver

or a similar tool.

Right tab

slot

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 53 54

Sem comentários

Quantum 1200 Series DAT Autochanger Guia do Utilizador Página 11